Sent In By Customer - Vikram Mishra
Bolton
Photo 1 - marking postion for the sensors with blu-tac
Photo 2 - Drilling holes in the bumper, before doing this I made sure I planned how to complete the wiring through the bumper, luckily there was a small hole in the boot
Photo 3 - Fitting the sensors, note the wires at the bottom that need tidying up
Photo 4 - Stripping the reversing sensor wire
Photo 5 - Soldering the parking sensor wire to the reversing light wire, I needed to extend this wire as the reverse light is located on the boot area that opens up in the air and wire this all through the boot trim
Photo 6 - Mounting the sensor box in the boot and I tidied all the wiring up
The sensors are great, work really well. I mounted the audio buzzer in a panel near the rear boot, as was too quiet to mount in the boot, makes parking so easy now.
No comments:
Post a Comment