Dolphin Parking Sensors For Audi A5

Audi A5 with front parking sensors fitted. We supplied two sensors in white to go into the bodywork either side and two matt black sensors for the centre grille. Fitted by our Kent installer.

Audi TT fitted front and rear with parking sensors

Audi TT fitted front and rear with Dolphin automotive gloss black micro sensors. Micro sensors are required especially for the front as space is so limited.

Merc CLK With Dolphin Parking Sensors

Fitted in Woking using our mobile fitting option this is one of our Micro sensor kits which go very well on Mercedes, fitted to a Merc CLK 2005.

 

Parking Sensors Fitted to Silver Mercedes C200

This Mercedes C200 has been fitted with Dolphin Micro Sensors, specifically a DMS400 kit, which has smaller sensors needing just an 18mm hole for a more discreet and original look. These have been supplied in our standard silver and fitted in Camberley in Surrey as part of our fixed price fitting option.

Chrysler Sebring With Dolphin Parking Sensors

Chrysler Sebring 2008 fitting with Dolphin Micro Parking Sensors in gloss black in Birmingham by Dennis as part of our mobile installation service.

 

Dolphin Parking Sensors For BMW 5 Series

Front parking sensors fitted to a BMW 5 Series with our standard silver colour. Fitting carried out with Colin, one of our nationwide installer network who will come to you at home or work to fit.

Dolphin DPS400 Fitted to Audi A4 09 Reg

Sea Blue DPS400 Audio Parking Sensors Kit fitted to 09 registration plate Audi A4. Fitting was carried our by Andrew Rossall of Blackpool Communications.

Parking Sensors Fitted to BMW Z4 Roadster

BMW Z4 in with grey sensors from a Dolphin DPS400 rear parking sensor kit fitted by Dennis is Epsom as part of our nationwide mobile installer network fitting at a fixed price at your home or place of work.

 

Ford S-Max Dolphin Installed

Aji VELU
London

Dolphin Display kit in black fitted to a Ford Focus S-Max. Photo's show that bumper has been drilled without removal. The central 2 sensors look a little lower than we would normally advise but customer reports they work fine. Outer two sensors mounted at high up for convenience of fitting.

"I have Installed the parking sensors Ford S-max and they work really well. Thank you"

Dolphin DPS470 Parking Sensors Fitted to Toyota Prius

"I am very satisfied with the parking sensor system recently purchased from 
you, here are pictures and a brief description of fitting sensors to a 2010 Toyota Prius which you may wish to use on your website." 
Tony Hegarty

Toyota Prius 2010

The sensors can be fitted on the rear bumper cover without removing it from the car. The metal bumper runs about midway inside the cover so that the sensors can be fitted either above or below this without obstruction.  Fitting them around 57 cm above the ground sets them above and nicely clear of the bumper and within the recommended 40 – 70 cm. 

As the contour of the bumper cover would tilt the sensors slightly upward the spacers were used, which brought them level. In order to feed the sensor wires into the boot it is necessary to move two plastic panels from underneath the car.  These are held in place by a number of plastic pins, three plastic screws, and one 10mm bolt.  The plastic pins are removed by popping the centre of the pin outward and the whole pin will then come out easily.  The pins can be reused when the job is done.  A rubber grommet in the rear left side of the wheel well makes passing the wires forward easy and there is room for the “control box”  behind the small plastic storage compartment directly under the light cluster making connection to the reversing light convenient.

The wires attached to the reversing light were too tight to allow a scotchlock to be used so the connection was soldered.  A good earth connection is available at the nearby chrome cargo hook. The wireless version was used so the display can be fitted in a number of convenient places.

Volvo V70 With Dolphin Parking Sensors

Volvo V70 which has had Coal Grey sensors fitted in the plastic strip at the rear of the vehicle which is a W reg and the plastic has faded on the bumper so the sensors are a little obvious but not out of place.
 
Please note that these are photos taken the day the sensors are fitted. The customer in question with the Volvo had recently reversed into a post putting a crease in his bumper and so decided to get some sensors fitted to stop him doing this again.