Detailed Dolphin Parking Sensor Installation

Lee Knowles
Cheshire

Dolphin Audio in silver fitted to a Honda Civic. Masking tape is used to accurately identify the drilling location and it helps hold the drill bit in place when drilling and protect the paintwork. Ideally you want to mount them 50cm off the ground, you can get away with less but may need to use the wedges included in the kit to angle the sensors up slightly if you start mounting at 40cm or less.

The bumper has been drilled in situ but them removed to feed the cabling through to the boot where you can see a hole has been drilled and gromit fitted to pass the cabling through, you can alternatively use some silicone sealant. Power lead has been soldered onto the reverse light feed but a connector block is a more common solution. 

Dolphin Fitted to Mazda CX-7

Mazda CX-7 parking sensors fitted in Reading by Dennis as part of our fixed price mobile installation service. As the bumper is curved on the lower sensors the wedges that come in the box on the DPS range of parking sensors have been used to lift/angle the sensors up slightly.

Dolphin Parking Sensors For Vauxhall Combo Van

Vauxhall Combo Van. The sensors are fitted lower than we would normally advise but a crash bar above prevents you going any higher. This is a DPS400 with the standard sized sensors that come with the wedges and these have been fitted to angle the sensors up slightly and as a result the location works.