The front and rear kits were both audio only kits. The 7.5mtr motor home rear kit was all installed into a water proof box under the van at the rear. This protects the cables from weathering as most will run all 4 cables to the front under the Chassis! Not a good idea......
Customer went for simple on/off switch for front rather than the Automatic CanM8 so that he could be in complete control of when the sensors were on off and on.
The 2 sensors either side of number plate had to be placed a little wider than Dennis would have liked as shown on this motor as the Front Crash bar is situated immediately behind the panel.
No comments:
Post a Comment